TML32 Dixon Valve Long Style Carbon Steel Tubular Male Pipe Threaded (NPT) External Swage Stem - 2" Hose ID

  • $28.23
  • Recommended for use where additional retention is required due to higher working pressures or end pull, on most one and two wire braid reinforced hoses, fiber reinforced (braided or spiraled) with or without helical wire such as: oil and suction discharge hose, barge and dock loading and unloading hose as well as L.P. gas hose, anhydrous ammonia hose, acid chemical hose and air and water hose.
  • Designed for hose ID's 1-1/4"" - 10". The ferrule size depends on the hose OD.
  • Tubular type.
  • The coupling system requires no bolts and results in a clean coupling with no protrusions.
  • The Holedall coupling provides long-lasting efficiency and safety.
Safety Notes:
  • Dixon Holedall stems and ferrules are specifically designed to be used together as a coupling system.
  • Due to differences in dimensions and tolerances, for safety reasons, do not use other manufacturer's stems or ferrules with Dixon Holedall products.
  • Do not use a wrench or vice on ferrule.
  • Holedall couplings, regardless of coupling style, are never to be used for steam service at any pressure.
  • Holedall fittings are not to be used with cable reinforced high-pressure hose, 4 or 6 braid wire hydraulic hose or any other service not listed in the recommendations.
  • Externally swaged Holedall couplings, to perform satisfactorily, must be applied properly in accordance with Dixon's assembly procedures, using correct die and ferrule for that particular hose end OD.
  • Hose service working pressure (including surges and spikes) is never to exceed the maximum recommended working pressure for the fitting. The assembly's (hose + coupling) maximum working pressure is the lesser of the hose rated working pressure or the coupling rated working pressure.
  • Media being transported through the hose should be compatible with the stem material. Compatibility of ferrule material with the environment in which it will be used is recommended.
Part Number Hose ID Style Max Working Pressure Weight (Lbs.)
TML20 1-1/4" Long Style 1000 PSI 1.0600
TML24 1-1/2" Long Style 1000 PSI 1.0000
TML32 2" Long Style 1000 PSI 1.5500
TML40 2-1/2" Long Style 1000 PSI 3.3900
TML48 3" Long Style 1000 PSI 4.4100
TML64 4" Long Style 850 PSI 6.7200
TML80 5" Long Style 750 PSI 13.0000
TML96 6" Long Style 700 PSI 17.9000
TML128 8" Long Style 600 PSI 34.5600
TML160 10" Long Style 550 PSI N/A